Wilcom T207 General Test Set

New Wilcom T207

Our Price:

$8,750.00

Model: T207
Manufactured by: Wilcom
See all Wilcom equipment

Wilcom T207 datasheet & specifications

Test Set

Wilcom T207

Longitudinal Balance Test Set

The T207 Longitudinal Balance Test Set is designed to measure the longitudinal balance of single-port or two-port circuits and devices. This test set permits evaluation of relays, feed coils, networks, long-line units, amplifiers and other equipment present on the typical communications circuit. These devices may have poor longitudinal balance and thus contribute to the susceptibleness of the facility.

The measuring technique and circuit configuration conforms to the IEEE standard 455-1976 for Longitudinal Balance Measurements. Longitudinal balance measurements may be made at single frequencies in the range of 40 Hz to 4 kHz. Also, as an added feature of the Model T207, a figure of merit balance measurement may be made using a shaped waveform which is representative of a power induced noise spectral distribution. Single frequency measurements on circuits with balance approaching 80 dB can be made with a typical accuracy of ± 1 dB.

Features:

Balance Measurements: 10 to 90 dB

Direct Reading of Balance in dB

Measure 1-Port and 2-Port Circuits or Devices

Quasi-rms Meter Circuit

Built-in Calibration Circuit

Built-in Longitudinal Signal Sources Single

DC Current Source for Circuits Under Test

Verification of Validity of Measurement

Test Equipment Connection ships & sells Test Equipment World Wide
Unless forbidden under US export or manufacturer restrictions.

Fill out the form below for more information about the WILCOM T207

* Indicates Required Information

Your Details:

Your Name	*
Your Company	*

Email	*
Verify Email	*

Telephone
Fax

Country	*
State
Address
City
Zipcode

Referal:

Additional Comments:

Please Enter the following Verification Number and then click Send

Similar Products

WILCOM T207E

WILCOM 3207